Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

SNMP Trap definition for c6kxbar

snmp-server enable traps c6kxbar intbus-crcexcd intbus-crcrcvrd swbus

Can someone explain what this trap does? I cannot find an explanation on CCO

thanks

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: SNMP Trap definition for c6kxbar

These traps are only applicable for crossbar switching fabric modules.

3 REPLIES
Cisco Employee

Re: SNMP Trap definition for c6kxbar

This command controls the following traps from the CISCO-CAT6K-CROSSBAR-MIB:

cc6kxbarIntBusCRCErrExcdNotif

cc6kxbarIntBusCRCErrRcvrdNotif

cc6kxbarSwBusStatusChangeNotif

The description of these objects is as follows:

cc6kxbarIntBusCRCErrExcdNotif NOTIFICATION-TYPE

OBJECTS {

entPhysicalName,

entPhysicalVendorType

}

STATUS current

DESCRIPTION

"A cc6kxbarIntBusCRCThreshExcdNotif notification

is sent by the system when the system has

detected that the internal bus CRC error on

a physical entity (such as a module) as specified

by entPhysicalName has exceeded the fatal threshold."

::= { ciscoCat6kXbarMIBNotifs 2 }

cc6kxbarIntBusCRCErrRcvrdNotif NOTIFICATION-TYPE

OBJECTS {

entPhysicalName,

entPhysicalVendorType

}

STATUS current

DESCRIPTION

"A cc6kxbarIntBusCRCErrRcvrdNotif notification

is sent by the system when the system has

recovered as the internal bus CRC error on

a physical entity (such as a module) as

specified by entPhysicalName has fallen below

the normal threshold."

::= { ciscoCat6kXbarMIBNotifs 3 }

cc6kxbarSwBusStatusChangeNotif NOTIFICATION-TYPE

OBJECTS {

cc6kxbarSwBusSwitchingStatus,

cc6kxbarSwBusFailureDuration

}

STATUS current

DESCRIPTION

"A cc6kxbarSwBusStatusChangeNotif notification

is sent by the the device when there is change

in switching status of the switching bus as

monitored by cc6kxbarSwBusSwitchingStatus."

::= { ciscoCat6kXbarMIBNotifs 1 }

New Member

Re: SNMP Trap definition for c6kxbar

Thanks for the quick reply. Is this used for just the fabric module or also for the sup720?I have all new sup720s and trying to find out if this is needed going forward.

Cisco Employee

Re: SNMP Trap definition for c6kxbar

These traps are only applicable for crossbar switching fabric modules.

693
Views
0
Helpful
3
Replies