Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

SNMP trapping PRI channels up/down

Hi guys.

I am re-configuring some routers to generate traps for our new monitoring tool.

I have noticed that after I applied the snmp trap configs that we are getting traps for PRI channels (30 voice channels), which I wouldn´t like to. This happens when users are using the voice channels on demand. When they hang up, the used channel goes down and I get a trap.

Basically, regargint the controller, the only interface that I must monitor is the signaling one (my case is the channel 0/3/0:15) or if the entire controller goes down.

Below, the snmp trap config:

snmp-server ifindex persist

snmp-server trap-source Loopback0

snmp-server enable traps snmp linkdown linkup coldstart warmstart

snmp-server enable traps envmon

snmp-server enable traps isdn layer2

snmp-server enable traps isdn chan-not-avail

snmp-server enable traps isdn ietf

snmp-server enable traps bgp

snmp-server enable traps hsrp

snmp-server enable traps ipsla

snmp-server enable traps voice poor-qov

Could you please help me to figure out how I can solve this?

Also, if you guys have any other advises and more ways to monitor the voice environment.

Thanks in advance

Everyone's tags (7)
1229
Views
0
Helpful
0
Replies