Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

SNMP V3/Cat4000

I have SNMPv3 working on all my other switches but get a failure trying to add a view to the CAT4000. I tried using, system, root, and ios but get the message that it's "not a valid OID. What is the SIMPLEST secure config to allow Ciscoworks to access this switch via SNMPv3?

1 REPLY
Silver

Re: SNMP V3/Cat4000

Cat4000 software release 5.4 supports SNMPv3. check the following link for configuring a view on Catalyst 4000 :

http://www.cisco.com/en/US/products/hw/switches/ps4324/products_command_reference_chapter09186a00801fd939.html#wp1025704

105
Views
0
Helpful
1
Replies