Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

snmp v3 *tv error

When devices on our network lose power or reload for whatever reason, we are losing our v3 snmp command to what seems to be a default value inserted by the devices. when this happens, we lose reachability with ciscoworks, and it requires we go back into the device and reapply the command below.

the command we are using:

snmp-server group $$Value$$ v3 auth

the sh run command after a reload:

snmp-server group $$Value$$ v3 auth notify *tv.FFFFFFFF.FFFFFFFF.FFFFFFFF7F

we have tried placing strings at the end of our snmp command, to see if we could stop the default placement of the *tv string to include

read, write, and notify strings with no success. we have noticed that the devices are also placing v1 and v2c snmp groups with the *tv string in the notify field, on every reload.

Thank you for your help!

-fox

2 REPLIES
Blue

Re: snmp v3 *tv error

Here's a potential workaround to your problem:

https://supportforums.cisco.com/message/3120162#3120162

New Member

Re: snmp v3 *tv error

thank you for the help. i literally found this 2 hours before you replied. im still working it, but ill post when i find

out if it works.

thanks again

-fox

215
Views
0
Helpful
2
Replies