Can you configure LMS 2.6 to use both SNMPv2 and v3 at the same time or do you have to decide what version to run? Most of the times you have invironments with high integrity and therefore mixed versions of SNMP.
LMS can be made to work with both SNMPv3 and v2c, but not on the same device. That is, given device A, you must choose whether or not you want LMS to manage device A with SNMPv3 or SNMPv1/v2c. There is no fallback in LMS from v3 to v1/v2c. Only configure one set of SNMP credentials per device. If you configure any v3 credentials for a device, LMS will opt to use v3 and ONLY v3 for that device.
However, given device B with device A managed with SNMPv3, if only SNMPv1/v2c community strings are configured for device B, LMS will only use v1/v2c to manage device B while happily managing device A with SNMPv3.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...