Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

SNMP View Configuration Question

Hi Guys

What i would like to do is setup a "snmp view" and restrict access to specific interfaces and then limit access to certain mibs.

The problem is i have 10+ interfaces that i will need to snmp get from.

and if i have to define every OID for each interface then it will make my view config very large for example.

If i want to see ifInUcastPkts for 3 interfaces

OID 1.3.6.1.2.1.2.2.1.11

My SNMP view would be

snmp-server view roview ifEntry.11.10116 included

snmp-server view roview ifEntry.11.10124 included

snmp-server view roview ifEntry.11.10601 included

if i want ifAdminStatus

OID 1.3.6.1.2.1.2.2.1.7

snmp-server view roview ifEntry.7.10116 included

snmp-server view roview ifEntry.7.10124 included

snmp-server view roview ifEntry.7.10601 included

is there a way to cut down on the config using wildcards? and still have some sort of security

3 REPLIES
Cisco Employee

Re: SNMP View Configuration Question

You can use a '*' as a wildcard in views. See http://www.cisco.com/en/US/docs/ios/12_3/configfun/command/reference/cfr_1g11.html#wp1033027 for more details.

New Member

Re: SNMP View Configuration Question

Thats fine i did know that the wildcard existed but it only denotes a specific sub tree.

in my example i dont think it will work as if i use

snmp-server view roview ifEntry.*.10116 included

then all of the ifEntry.* subtree will be visible for that interface.

Cisco Employee

Re: SNMP View Configuration Question

Yes, that's true. There is no range wildcard or mask that can be applied.

589
Views
0
Helpful
3
Replies
CreatePlease to create content