Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

SNMP WALK

Hi,

The attached is the output of the snmp walk on reacheable device,Which lines indicates that the device is reacheable through LMS????????

If suppose any of the devices not reacheable what would have been shown in SNMP Walk??????

Thanks

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: SNMP WALK

You will get the following error if the device is not reachable.

Failed to snmpwalk the device. Please check your community string and starting OID, and try again.

4 REPLIES
Cisco Employee

Re: SNMP WALK

The fact that you got any response indicates that the device is reachable. If it had not been reachable, you would have gotten an error about the device being unreachable, and to check timeouts and credentials.

New Member

Re: SNMP WALK

Hi,

From ur above mail i understand that if the device is unreacheable it will give an error otherwise not?? Correct me if am wrong.

Thanks,

Re: SNMP WALK

It the device is not reachable as Joe said, you will have an error message.

In the attachment you posted, the device is clearly reachable as it responds to snmpwalk with the values for the OIDs it is queried.

Cisco Employee

Re: SNMP WALK

You will get the following error if the device is not reachable.

Failed to snmpwalk the device. Please check your community string and starting OID, and try again.

581
Views
0
Helpful
4
Replies