Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

Blue

snmpset: Agent reported error with variable #1.

I find a few CatOS 8.4.4 cat6k's are returning "snmpset: Agent reported error with variable #1." to the following:

snmpset -c snmp-write-community-string switch-name .1.3.6.1.4.1.9.2.1.55.xxx.xxx.xxx.xxx OctetString switch-name.config

where xxx.xxx.xxx.xxx is the IP addr of the tftp server.

When I ran the above snmpset commands manually against one of these switches, the first attempt delivered only 34kb of the total of over 400kb of config. Running snmpset a second time got the full switch config to the tftp server.

Against other problem switches, however, I keep getting "snmpset: Agent reported error with variable #1." on manual attempts.

I know OLD-CISCO-SYS-MIB is deprecated (on both CatOS and IOS? This link only mentions IOS: http://www.cisco.com/cgi-bin/Support/Bugtool/onebug.pl?bugid=CSCdk33879), but that's another subject.

1 REPLY
Red

Re: snmpset: Agent reported error with variable #1.

For CatOS, you may want to use the CISCO-STACK-MIB. Check this out:

http://www.cisco.com/en/US/tech/tk648/tk362/technologies_tech_note09186a0080094aa3.shtml

284
Views
0
Helpful
1
Replies