I am trying to get issue CLI commands to running-config using the "snmpset" command. The command below appears to take just fine, but the commands are not reflected in the running-config. The SNMP RW string I'm using has vdc-admin rights, so I'm not sure why the commands do not take. The command uses a config file (188.8.131.52) on the server I'm accessing the device with. I don't think it's the command so much as there seems to be an issue with the device setup itself. It's a Nexus sub-vdc.
Any help is greatly appreciated. I'm pulling my hair out.
snmpset -v2c -c ATT-DIMERW 184.108.40.206 .220.127.116.11.18.104.22.168.22.214.171.124.1.2.3194 i 1 .126.96.36.199.188.8.131.52.184.108.40.206.1.3.3194 i 1 .220.127.116.11.18.104.22.168.22.214.171.124.1.4.3194 i 4 .126.96.36.199.188.8.131.52.184.108.40.206.1.5.3194 a 220.127.116.11 .18.104.22.168.22.214.171.124.126.96.36.199.1.6.3194 s 188.8.131.52 .184.108.40.206.220.127.116.11.18.104.22.168.1.14.3194 i 4
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...