I want to know if is it possible to configure 3 trap snmp on the same cisco router because we have 3 network server management means enable trap on the same device to supervise by for example LMS ,NAGIOS and OpManager
Yes it is very much possible and infact it is vey commonly used configuration. You can add multiple destinations to send traps, however recommended is to have maximum of four, else it may take a toll on your CPU from SNMP Engine process. Though, if the devices doesn't have much load, you can certainly add a couple of more.
Issue the snmp-server host global configuration command to specify the recipient of an SNMP notification operation.
Following is the syntax to add hosts/server IP to as destination for SNMP Trap IP:
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...