I am trying to setup VPN monitoring for a srp527w Cisco.
This is my first attempt at this so "easy to understand" instructions would be a great help, i have done some searching and its difficult to decipher relevant and irrelevant information based on my limited exposure to this technology.
all help will be greatly appreciated.
I have gotten as far as enabling SNMP on the device itself, havent gotten any further.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...