I've got an issue I hope someone can help with. I have 2 x 4510 Catalysts and 1 x 4506 Catalyst switches that have been relocated within my estate. Since the move my LMS 4.2 seems to be unable to perform a config collection or carry out any sort of netconfig job on those three devices.
LMS is set to use SSH and if I check by using PuTTY from the server or my own PC all is ok but when I try a "reachability status" check I get the following
"Could not detect SSH protocols running on the device TFTP is not supported as a connection protocol for VLAN Fetch, Only TELNET and SSH are supported as connection protocols for VLAN Fetch TELNET: Failed to establish TELNET connection to x.x.x.x - Cause: Connection refused."
I've tried to delete the devices and re-add them but it's made no difference.
SSH is obviously running ok as I can PuTTY from anywhere else it's just the LMS application itself which can't connect
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.