Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

SSH credentials in LMS 3.0

Can anyone tell me where I can edit/add the SSH credentials for RME 4.1. Under RME/Edit Device credentials, I find only snmp, telnet, enable etc. but no option to enter ssh. however when I do a "Management Stn. to Device" check there is an option for "ssh" credentials.

Unless it is being called by anotehr name? I would like to do this (edit/add) ssh through the gui as well as bulk (via csv files)

Any help would be appreciated.

Thanks

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: SSH credentials in LMS 3.0

Yes to all questions.

3 REPLIES
Cisco Employee

Re: SSH credentials in LMS 3.0

LMS stores all credentials in DCR. The primary and secondary username and password credentials can be modified under Common Services > Device and Credentials > Device Management. The same credentials are used for telnet and SSH. The protocol used is determined by the various sub-application's protocol order.

New Member

Re: SSH credentials in LMS 3.0

Thanks,

Does this mean that I can use the same fields (primary username or secondary username ) for my ssh fields in the csv files as well for Bulk import?

If I do not use ssh v2 or acs for some devices, can I just leave the username blank and put in the password (telnet) and enable (enable secret)?

Cisco Employee

Re: SSH credentials in LMS 3.0

Yes to all questions.

163
Views
2
Helpful
3
Replies
CreatePlease to create content