Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

SSH failed to device

Hi Team

when i am trying to access the swich though SSH, its getting failed, Plse find the attached screenshot for the same.

Even we are able to SSH from Putty.

LMS 2.6

Regards

Vaibhav

7 REPLIES
New Member

Re: SSH failed to device

Please verify configuration fetch protocol and package version.

Hope this helps.

Regards.

Andrea

Cisco Employee

Re: SSH failed to device

This shows nothing about SSH. It looks like you ran a Device Credential Verification job, and only selected telnet. Re-run the job, and choose SSH, and Enable by SSH, and see if that works.

New Member

Re: SSH failed to device

Hi Clark

where we need to choose SSH and where to enable SSH to get access of device only through SSH.

Regards

Vaibhav

Cisco Employee

Re: SSH failed to device

You choose the protocols to test when creating the Device Credential Verification job. There will be a series of checkboxes.

To make sure RME only uses SSH, you have to set your protocol orders accordingly under RME > Admin > Config Mgmt > Transport Settings.

New Member

Re: SSH failed to device

Hi Clark

We can do that but let me know if on other devices where ssh not configured than weather we are able to add them or not.

Regards

Vaibhav

Cisco Employee

Re: SSH failed to device

If you need to support other protocols, add them to the protocol order lists after SSH. That way, SSH will be tried first, and if it fails, then RME will fall back to other protocols.

New Member

Re: SSH failed to device

Hi Clark

Thanks a lot..

Regards

Vaibhav

173
Views
0
Helpful
7
Replies
CreatePlease to create content