We recently installed the LMS 2.6, we use SSH to access our network devices. However using LMS we are unable to access the devices using SSH. We are getting an error stating SSH client needs to be configured in the java control panel.
So I had configured the following entry in the java control panel (as per the campus manager user guide from cisco website) ...
But still not working, can someone give your inputs..
I have one more question regarding the java plugin...
As per the LMS installation guide the Java plugin version to be used with LMS 2.6 is 1.4.2.08, but when you try to access the LMS a java plugin with version 126.96.36.199 gets installed automatically. However I have seen in one of the thread you have mentioned that we should use the java plugin version of 188.8.131.52
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...