Make sure SSH is selected as a protocol under RME > Admin > Config Mgmt > Transport Settings for all of the config management applications (i.e. Archive, Netconfig, Config Editor). You may also want to check the "Use SSH for software image upgrade and software image import through CLI(with fallback to TELNET)." box under RME > Admin > Software Mgmt > View/Edit Preferences if you want to use SSH instead of telnet when doing image management jobs.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...