Could anyone please tell me how we can check the status of the health probes defined for the real servers on an ACE blade through snmp please? We loaded following mibs : CiscoSlbMIB (OI .161) , CiscoSlbExtMIB (OI .254) and CiscoSlbHealthMonMIB (OI .508).When we do a snmpwalk for .508 we NEVER get any values.Do we something wrong?Do we have to load a certain ACE image ?
In the description of the CISCO-SLB-MIB I found SlbRealServerState which I'm interested in.However if I do a snmpwalk of the OID (.18.104.22.168.22.214.171.124.126.96.36.199.1.4) the result is "no MIB objects contained under subtree".Nevertheless there are Reals Servers configured on the blade.Could you explain me why I can't see these through snmp plse?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...