Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Blue

Status of cat6k secondary supervisor

Does anyone know whether the following output corresponds to the Hot standby Sup in slot 6 going into "unknown" status, when Module 2 is in fact unoccupied?

#show facility-alarm status

System Totals Critical: 1 Major: 0 Minor: 0

Source Severity Description [Index]

------ -------- -------------------

Physical Slot 2 CRITICAL Active Card Removed OIR Alarm [0]

Are there any syslog and/or SNMP monitoring options when Sups in SSO failover go into "simplex" mode?

#show redund

Redundant System Information :

------------------------------

Available system uptime = XX weeks, XX day, XX hours, 54 minutes

Switchovers system experienced = 0

Standby failures = 1

Last switchover reason = none

Hardware Mode = Simplex

Configured Redundancy Mode = sso

Operating Redundancy Mode = sso

Maintenance Mode = Disabled

Communications = Down Reason: Simplex mode

Current Processor Information :

-------------------------------

Active Location = slot 5

Current Software state = ACTIVE

Uptime in current state = XX weeks, XX day, XX hours, 54 minutes

Image Version = Cisco IOS Software, s72033_rp Software (s72033_rp-ADVIPSERVICESK9_WAN-M), Version 12.2(##)SXH#, RELEASE SOFTWARE (fc1)

Technical Support: http://www.cisco.com/techsupport

Copyright (c) 1986-2008 by Cisco Systems, Inc.

Compiled Thu 24-Jul-08 19:18 by prod_rel_team

BOOT = sup-bootdisk:s72033-advipservicesk9_wan-mz.122-##.SXH#.bin,1;slavesup-bootdisk:s72033-advipservicesk9_wan-mz.122-##.SXH#.bin,1;

CONFIG_FILE =

BOOTLDR =

Configuration register = 0x2102

Peer Processor Information :

----------------------------

Standby Location = slot 6

Current Software state = STANDBY HOT

Uptime in current state = XX weeks, XX day, XX hours, 54 minutes

Image Version = Cisco IOS Software, s72033_rp Software (s72033_rp-ADVIPSERVICESK9_WAN-M), Version 12.2(##)SXH#, RELEASE SOFTWARE (fc1)

Technical Support: http://www.cisco.com/techsupport

Copyright (c) 1986-2008 by Cisco Systems, Inc.

Compiled Thu 24-Jul-08 19:18 by prod_rel_team

Configuration register = 0x2102

203
Views
0
Helpful
0
Replies
CreatePlease to create content