Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

STP in topology view

When I used PVST and the root bridge is same for all VLANs. Only for VLAN 1 the root bridge is green in the topology view. When I filter STP for other VLAN the root bridge is grey:-( I use CM 4.0.5. When I changed the root bridge for VLAN 2 for example, the new root bridge for this VLAN is green. So is it some bug in the CM? Roman

2 REPLIES
Silver

Re: STP in topology view

configure STP parameters on a per port, per device, and across devices/\.view STP parameters on a per switch-cloud, per VLAN or instance, per port basis. For more info refer the following URL

http://www.cisco.com/en/US/products/sw/cscowork/ps563/products_installation_guide_chapter09186a0080378f91.html

Community Member

Re: STP in topology view

Hi,

I have the problem with display of the root bridge in the STP topology. The STP root bridge is only display for VLAN1:-( But I do n't see the root bridge for other VLANs:-(

107
Views
3
Helpful
2
Replies
CreatePlease to create content