set the stpxFastStartPortMode with the dot1dBasePort index because according to the description of stpxFastStartPortIndex the latter is the same as dot1dBasePort: "The value of dot1dBasePort (i.e. dot1dBridge.1.4) for the bridge port."
This works fine for ports, which have the dot1dBridge support (i assume all trunk and 'auto' mode ports) but fails for access ports (switchport mode access) because there are no dot1dBridge objects for these ports and therefore we have no link between the ifIndex/ifDescr and stpxFastStartPortIndex.
Because port fast has nothing to do with Trunk/no trunk ports, i guess this is an error in the MIB (description?). Are there any other MIBs which uses the same index as stpxFastStartPortIndex that we can use to retrieve it?
C2960 Software (C2960-LANBASEK9-M), Version 12.2(58)SE2, RELEASE SOFTWARE (fc1)
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...