I have two controllers (4404) installed with 4 ap_manager interfaces (i.e. no LAG). Controller 1 has 96 APs on it and is fine. The second controller has approximately 15 APs on it, and I keep getting constant and random errors while trying to set variables. Attached is a photo of at least 10 errors all at once. I also get "AP ID doesn't exist on this system". I have tried rebooting the controller and clearing the configs of the troublesome APs. The controller is running 184.108.40.206 and is in a production environment.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...