To have a management tool polling by SNMP some information like CPU load and memory load, I tried to find out the OID.
The supervisory card is a WS-X45-SUP7-E with a dual core CPU and 2G of memory.
IOS is IOS-XE 3.2.2
sh proc cpu Core 0: CPU utilization for five seconds: 3%; one minute: 2%; five minutes: 2% Core 1: CPU utilization for five seconds: 11%; one minute: 7%; five minutes: 6% PID Runtime(ms) Invoked uSecs 5Sec 1Min 5Min TTY Process 1 911 917 993 0.00 0.00 0.00 0 init 2 0 83 11 0.00 0.00 0.00 0 kthreadd
sh mem System memory : 2011604K total, 780166K used, 1231443K free, 85548K kernel reserved Lowest(b) : 699273216
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...