11-09-2006 08:50 AM
Hi,
In the Release Notes fot Cisco Works Common Services 3.0 there is a table that shows the supported server time zone, but I can't find the Brazil Time Zone GMT -3:00.
Is there any way to add a new Time Zone in CiscoWorks 3.0.5 ?
I need that cause I have a lot of routers in differente time zones.
Thanks in Advanced,
Andre Lomonaco
11-09-2006 09:07 AM
Typically, when customers have a lot of routers in different timezones, they standardize on UTC. However, if you cannot do this, and the specific timezone you want is not supported, you can simply have the device advertise their offset from UTC. So, if the devices send syslog messages with a timestamp of GMT-3, that should be fine. By the way, what is the abbreviation for your timezone?
11-09-2006 10:23 AM
Hi Joe Clarke,
Thank for your reply
Here in Brazil we have 4 timezones
EBST (GMT-3) Brazil (East, including all coast and Brasilia)
NORO (GMT-2) Brazil (Fernando De Noronha)
WBST (GMT-4) Brazil (West)
ACRE (GMT-5) Brazil (Trinity of Acre)
Some have DST, some not. If you need that information I will check for you...
My region uses EBST (GMT-3)
Thanks a Lot Again,
Andre Lomonaco
11-09-2006 10:38 AM
If these are the timezones the devices are advertising in their syslog messages, you can edit NMSROOT/MDC/tomcat/webapps/rme/WEB-INF/classes/com/cisco/nm/rmeng/fcss/data/TimeZone.lst, and add your TZ entries. For example, for EBST, add the following:
EBST=-30
Then restart dmgtd.
11-14-2006 11:42 AM
Hi Joe Clarke,
I couldn?t find thisfile
NMSROOT/MDC/tomcat/webapps/rme/WEB-INF/classes/com/cisco/nm/rmeng/fcss/data/TimeZone.lst
I?m using CiscoWorks 3.0.5
Can you help me locate this file ?
I need to install something beside the
typical installation ?
Thanks in advanced
Andre Lomonaco
11-14-2006 12:03 PM
On Solaris NMSROOT would be /opt/CSCOpx by default
On Windows its normally c:\Program Files\CSCOpx
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide