Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Switch interface capabilities through SNMP?

Below is an example of what one gets with the command "show interface capabilities module 4". My question is: Is there a way to get the same information using SNMP?

FastEthernet4/1

Model: WS-X4148-RJ-RJ-45

Type: 10/100BaseTX

Speed: 10,100,auto

Duplex: half,full,auto

Trunk encap. type: 802.1Q,ISL

Trunk mode: on,off,desirable,nonegotiate

Channel: yes

Broadcast suppression: percentage(0-100), sw

Flowcontrol: rx-(none),tx-(none)

VLAN Membership: static, dynamic

Fast Start: yes

Queuing: rx-(N/A), tx-(1p3q1t, Shaping)

CoS rewrite: yes

ToS rewrite: yes

Inline power: no

SPAN: source/destination

UDLD: yes

Link Debounce: no

Link Debounce Time: no

Port Security: yes

Dot1x: yes

Maximum MTU: 1552 bytes (Baby Giants)

Multiple Media Types: no

Diagnostic Monitoring: N/A

FastEthernet4/2

......

119
Views
0
Helpful
0
Replies
CreatePlease login to create content