Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Switch Port Usage for cli

Is it possible to get switch port usage information using the cli commands?

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Switch Port Usage for cli

These reports are not yet available via the CLI. They are looking to be added, however, in a future release.

4 REPLIES

Re: Switch Port Usage for cli

Marcie,

Type of switch?

What usage information are you after?

Cisco Employee

Re: Switch Port Usage for cli

These reports are not yet available via the CLI. They are looking to be added, however, in a future release.

New Member

Re: Switch Port Usage for cli

On 3750's switches there is a show controllers util

New Member

Re: Switch Port Usage for cli

We have 9 3750s in a stack and when I run "show controllers utilization" I get zeros for every interface and the last lines of output are:

Total Ports : 468

Switch Receive Bandwidth Percentage Utilization : 0

Switch Transmit Bandwidth Percentage Utilization : 0

Stack Ring Percentage Utilization : 0

It is strange that I get all zeros...does something else need to be configured?

588
Views
5
Helpful
4
Replies