Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

sync archive problems

re LMS 2.5.1 on W2k.

I'm trying to perform an archive of all configs however I noted that some of the devices from the device selector have greyed out boxes, why has this happened?

7 REPLIES
Silver

Re: sync archive problems

I think this happens when the required credentials for these devices are not yet entered.

Cheers,

Michel

New Member

Re: sync archive problems

Here's the screen shot of what I mean.

Cisco Employee

Re: sync archive problems

These devices are not supported by Config Archive. What type of devices are they? What are their sysObjectIDs? Exactly which version of RME do you have?

New Member

Re: sync archive problems

The devices are listed under

Cisco Network Modules, Cisco Catalyst 6000 Multilayer Switch Feature Card MSFC3.

Cisco Catalyst 3560 Series Switches, Cisco Catalyst 3560-48TS Switch

all are greyed out.

Running RME ver 4.03 as part of LMS 2.5.1

Ran the following snmpwalk -v 2c -c sysObjectID > sysObjectID.txt

which is attached

Cisco Employee

Re: sync archive problems

Please provide the list of contents in NMSROOT\MDC\tomcat\webapps\rme\WEB-INF\lib\pkgs and NMSROOT\www\classpath\com\cisco\nm\xms\psu\pkgs\rme. Also, what versions of the Cat3560 and Cat6000IOS RME packages do you have installed?

New Member

Re: sync archive problems

Ok, here's the attached lists requested, however the actual dates in the zip files are 18/1/07 in both locations.

I checked the version of the packages (common services, software centre device update) and it stated ver 1.0.

Interesting to note as well that there are no device type counts for for Campus Manager or CS albeit for a package called MDF ver 1.6

Cheers

Tony

Cisco Employee

Re: sync archive problems

You don't have a Cat3560 package so that explains why those devices show as unsupported. The latest version of the Cat6000IOS package is 6.0.

What you should do is go to Common Services > Software Center > Device Update and select Common Services and Resource Manager Essentials. Then click Check for Updates. Select Cisco.com as the Source Location. When it returns the list, check everything, and install. If all goes well, that should give you latest Cat6000IOS and Cat3560 packages which should then allow you to fully manage these devices.

166
Views
0
Helpful
7
Replies