Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

syslog analyzer message

i have this kind of message when i open up analyzerDebug.log.[ Tue Aug 14 15:01:54 GMT+08:00 2007 ],INFO,[main],newsyslogqueue queue created with max size 100000

any idea for this? and some devices are not send syslog message to the LMS it because of that? thanks in advanced.

Cisco Employee

Re: syslog analyzer message

This is just an informational message, not an error or debug. You need to start at the device and work your way up.

Is the message from the device reaching the server? If so, is it making it to the syslog.log or syslog_info?

If it is there, is the device managed in RME?

Can you try generating a config change syslog to see if it makes it?

New Member

Re: syslog analyzer message

thanks for your fast reply.

yes,all the syslogs are going to syslog.log i can check them on it.devices are managed by RME as well.i can see the syslog message from half of the devices while i am using report generator.only another half has this kind of problem.syslog messages are going into syslog.log but cannot show inside report generator.

anything i need to check?

Cisco Employee

Re: syslog analyzer message

First enable syslog debugs

Select one device, generate the config change message. Then make sure it reaches the log file

Then wait a few minutes for RME to process this message

Then generate a standard syslog report for this device, does it show the message?

Anything in the debug output for the device IP Address or name?

New Member

Re: syslog analyzer message

when the change has been made on router,all the messages are going to syslog collector that i can see in syslog collector status.but all the messages are under invalid.if some messages are going out of invalid,they are under filter and as the result,i can see syslog in syslog.log but not in report.thanks for your time to reply and really appreciate it.

another thing is after i do pdterm and pdexec SyslogCollector,pdshow shows that SyslogCollector is running.but i go to syslog collector status,all the fields are n/a and i need to do subscribe the syslogcollector.log it says subscribe list is empty.propfile path is not found though file is inside the path. and the path is something weird such that c:/program/cscopx/mdc/......./c:/program/cscopx/mdc

the file path like the middle of path,it starts from the start "c:/...." and so this relating to his problem?