Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Syslog Analyzer will not read the Syslog file

I am using CiscoWorks LMS3.0.1 and I can see the syslog.log file increasing, but when I go into the RME to look at the syslog entries, there are not any. What should I look at in CiscoWorks to make it work.

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Syslog Analyzer will not read the Syslog file

The filters are defined under RME > Tools > Syslog > Message Filters. Please post a screenshot of that page.

3 REPLIES
Cisco Employee

Re: Syslog Analyzer will not read the Syslog file

Make sure the SyslogCollector and SyslogAnalyzer processes are running, and check that the Analyzer is subscribed to the Collector under RME > Tools > Syslog > Syslog Collector Status. Make sure that the messages being written to the log are valid syslog messages. You want to see the Forwarded count increasing the the Syslog Collector Status. Additionally, check your filters to make sure you are not filtering out the messages arriving in the syslog.log.

New Member

Re: Syslog Analyzer will not read the Syslog file

I have checked the processes and they are running and the analyzer is subsucribed, I see the count increasing there and I have no filters, (that I know of) in place, where can I check for sure.

Cisco Employee

Re: Syslog Analyzer will not read the Syslog file

The filters are defined under RME > Tools > Syslog > Message Filters. Please post a screenshot of that page.

348
Views
0
Helpful
3
Replies
CreatePlease to create content