I have turned on the automated action to send an email when we have an event like a duplex mismatch. It works, however, it triggers 4 emails a minute. I could write a filter in outlook but it would still use outlook resources for every message. Has anyone found a good work around for this? I am using Ciscoworks 3.1
There is no built-in rate limiting in RME. You would have to use the Script feature for Automated Action, and build some logic into your script to do the rate limiting. I'm not sure if anyone has done such a script.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...