Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Syslog interface Up/down

I'm collecting the Syslog messages with Ciscoworks, but on Severity Level 3 I'm receiving lots of messages regarding interface up/down which I don't care.

Is there a way to disable that ? without disable all severity level 3? since there are other messages important? And can we configure which ports should log that messages? I care about server's port's or important port's, but not all users...

Thanks for your help!

Jorge Sousa

4 REPLIES
Red

Re: Syslog interface Up/down

In IOS, for each interface you may configure:

no logging event link-status

New Member

Re: Syslog interface Up/down

is there any command to apply on all ports by default?

Red

Re: Syslog interface Up/down

Unfortunately not.

New Member

Re: Syslog interface Up/down

You could try redefining the syslog message to a lower level.

Take the syslog number that you're getting, and enter a command on your pix that goes like this:

logging message 109012 level warning

replace 109012 with the link up/down specific number

hmm.. consider that you do want some but not all, the other alternative is to filter the device description for those specific ports, perhaps.

191
Views
9
Helpful
4
Replies
CreatePlease login to create content