Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Syslog messages only from vlan and trunk interfaces

Hi,

I have LMS 2.6 and we have configured syslog in our 100 devices for sending syslog messages to the LMS.

Now we want to configure CiscoWorks for sending mails when a VLAN or a trunk interface goes down or up, but not any interface, only vlan or trunks.

How could we do it?

Thank you very much.

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Syslog messages only from vlan and trunk interfaces

There is no way to do this unless you want to create Automated Actions for each device, and match on a known list of VLAN/trunk port interfaces.

That said, assuming your switches are running recent enough code, you could use the Embedded Event Manager to do this directly from the device.

4 REPLIES
Cisco Employee

Re: Syslog messages only from vlan and trunk interfaces

There is no way to do this unless you want to create Automated Actions for each device, and match on a known list of VLAN/trunk port interfaces.

That said, assuming your switches are running recent enough code, you could use the Embedded Event Manager to do this directly from the device.

Blue

Re: Syslog messages only from vlan and trunk interfaces

For Vlan updowns only:

Facility : LINK

Sub-facility : *

Severity : *

Mnemonic : UPDOWN

Description : Interface Vlan*changed state to*

Community Member

Re: Syslog messages only from vlan and trunk interfaces

Thanks but the pattern "vlan" never appears in the syslog messages, always "GigabitEthernet..." or "FastEthernet...".

Blue

Re: Syslog messages only from vlan and trunk interfaces

Actually, the IOS would create syslog messages if "logging link-status" is configured under each VLAN interface, or globally.

326
Views
3
Helpful
4
Replies
CreatePlease to create content