Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Syslog not working via VPN using NAT

Hi

Syslog messages are not being logged from network devices to Ciscoworks server. My network is described below.

CW-->vpn router-->VPN tunnel-->Cisco 3000 concentrator-->PIX-->network devices.

There is nat translation being done on the Vpn router for the network devices ip address.

Only syslog messages are not being logged to Cw. Snmp traps from devices to cw is working fine (thru DFM) Snmp polling from CW to devices is working fine (Thru RME).

Devices have been added to CW using the Nat ip (eg if org ip of device is a , it is natted to b on the vpn router , so b is the ip address being used on Cw).

Syslog configuration on the device

logging on

logging trap errors

logging CW ip address

Regards

Vijay Sequeira

1 REPLY
Silver

Re: Syslog not working via VPN using NAT

check if an access-list for the interesting traffic for the syslog server host ip address is configured in the PIX device.

113
Views
0
Helpful
1
Replies