Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Syslog

Hi,

How do i enable my RME to receive syslog mesaages from devices.

I have configured all the devices in my network to send syslog messages to RME,but each time i make a change on my box in message is sent.

Why did i go wrong,please let me know.

Thanks for your reply.

5 REPLIES
Cisco Employee

Re: Syslog

Nothing needs to be done in RME. You need to make sure your devices are sending messages with a facility of local7 to the RME server.If the devices are not sending messages, then you need to double-check your config. In general, this is all you need:

logging 10.1.1.1

logging trap info

logging facility local7

Community Member

Re: Syslog

Where do i get to check this.

Thanks for your reply.

Cisco Employee

Re: Syslog

Do a show run on the device. You can also see this by doing a show logg.

Community Member

Re: Syslog

Do I need to configure all the three statements or just the first statement will do the work.

Please reply,thanks

Cisco Employee

Re: Syslog

Technically just the first since the other two are default. As I said, do show logg to see what the current syslog parameters are.

117
Views
0
Helpful
5
Replies
CreatePlease to create content