Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Highlighted
Community Member

Sysloging

We currently have Cisco 3750's running Version 12.2(25)SED1. I have sysloging enabled to a specific syslog server.

If I receive a syslog alert from a specific switch and try to verify this by jumping onto the switch and checking for errors I dont see anything in the logs. I have tried to enable logging buffered level 7 but this does not show anything in the logs. I was rebooting a device that is connected to the switch. Surely it should an entry for the interface going down to a device if it was rebooted ?

3 REPLIES
Blue

Re: Sysloging

You need the following per-interface config, in order to get syslog entry for interfaces going up/down:

logging event link-status

But, are you saying you find link status syslogs on the syslog server, yet not in the switch's logging buffer? Do you have the following configured?

! sends syslog to the switch logging buffer

logging buffered #### debugging

! sends syslog to pne or more syslog server(s)

logging trap debugging

logging 10.xx.xx.xx

Community Member

Re: Sysloging

Mistrvi,

I was right were you are, yesterday. Simply use the command "logging event link-status default"

Community Member

Re: Sysloging

Thank you !

153
Views
0
Helpful
3
Replies
CreatePlease to create content