Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

system MTU in MIB

The customer tried to use the following SNMP OID enterprises.9.9.276.1.2.1 on the Catalyst ME3400 with 12.2.44SE. From the SNMP object navigator this MIB exists in this IOS. But when the customer used the snmpwalk the following message appeared:

SNMPv2-SMI::enterprises.9.9.276.1.2.1 = No Such Instance currently exists at this OID.

Do you know if this OID is correct for system MTU on this platform??

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: system MTU in MIB

This object is not supported. You can use the ifMtu object to get individual interface MTU values, but not a system-wide value.

1 REPLY
Cisco Employee

Re: system MTU in MIB

This object is not supported. You can use the ifMtu object to get individual interface MTU values, but not a system-wide value.

276
Views
0
Helpful
1
Replies