Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

TELNET AND RELOAD FROM LMS 3.0

I am using Cisco LMS 3.0.From the devicee centre,how can i reboot a switch and when i click on the telnet link , it fails as well ?

Any idea how can i reboot a switch from LMS 3.0 and what configuration you need to do to telnet to it from the device cetre ?Is there any way you can clear the telnet session from the device centre ?

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: TELNET AND RELOAD FROM LMS 3.0

In order for telnet to work from Device Center, you need to have a telnet:// URL handler installed in your client's browser. On Windows, IE typically launches telnet.exe.

To reload a device, create a Reload Netconfig job under RME > Config Mgmt > Netconfig. Just select your device or devices, then select Reload from the task list.

2 REPLIES
Cisco Employee

Re: TELNET AND RELOAD FROM LMS 3.0

In order for telnet to work from Device Center, you need to have a telnet:// URL handler installed in your client's browser. On Windows, IE typically launches telnet.exe.

To reload a device, create a Reload Netconfig job under RME > Config Mgmt > Netconfig. Just select your device or devices, then select Reload from the task list.

New Member

Re: TELNET AND RELOAD FROM LMS 3.0

Both solutions worked.

Legendary

Well Done.

Thanks

Arif

183
Views
0
Helpful
2
Replies