Our client has LMS 3.0 installed to monitor their routers, switches, and firewall. Evrything seemed to work out fine except for the telnet connection when you right click on the device under Topology Services map. When you click on Telnet, a window would pop-up stating "Connecting to 184.108.40.206" where it should be 220.127.116.11 since that is the device's IP address. There are some that shows the correct IP but still cannot connect thru telnet.
I even tried to access telnet thru Device Center but to no avail.
Is this a bug on Ciscoworks LMS 3.0? Didn't encounter such problems with LMS 2.6 and 2.5. And I did the same procedure in installing all the modules and the device credentials are ok since I have already archived the configurations of most of the devices.
Telnet from the Topology Map is broken in LMS 3.0. This was fixed in LMS 3.0.1. As for Device Center, this is simply a telnet:// URL link. The actual handling of this URL depends on your browser and your client's config. Browsers typically launch telnet.exe.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...