I've launched a NetShow job against several routers. The job result is successful but appears the following message:
Deploy successful (TELNET: Failed to establish TELNET connection to 10.253.49.34 - Cause: Authentication failed on device 3 times. Primary Login Succeeded / Primary Enable Succeeded )
We have only access by ssh to the routers, no telnet is configured, so that message is OK. But, how could I configure CW to try only ssh connection mode to routers? Swiches use telnet instead of ssh...so I should configure only telnet as connection mode...
You can set the protocol order for Configuration Management applications such as Archive Management, Config Editor, and NetConfig jobs to download configurations and to fetch configurations. For NetShow, you can set the protocol order to download configurations.
You havent mentioned the LMS version as path to this feature would differ. I will provide navigation link for both lms 3 and 4.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.