I am running in wired problem. I have issue with telnet into a CISCO 2811 router.
Problem is when I telnet to router through PUTTY / WINDOWS CMD, telnet session hangs after 1 min of a successful login, but when I telnet to the same router through connected switch or other router it works fine and session don't hang.
Clear the Vty lines with âClear linesâ and try to telnet. A router appears to stop working when the system is not responsive to the console or to queries sent from the Telnet. This may also be the possible to hangs.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...