Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

telnet using loopback

can we telnet to IOS device using loopback address.

2 REPLIES
Cisco Employee

Re: telnet using loopback

You should be able to telnet to the loopback address providing it is a valid reachable address (may need a route to it) and that there are no ACL's blocking telnet to this address.

Red

Re: telnet using loopback

If you have defined loopback interfaces on the IOS device and assigned ip addresses to them, then yes.

732
Views
15
Helpful
2
Replies