We have a switch C3750 V12.2(44)SE which has to many ssh session, and we cannot access anymore to this switch, because telnet is disabled. SNMP access is possible. Is it possible to kill the ssh processes or is there another solution available to get ssh running. Or can is disable the access-list with any snmp commands?
You can push the configlet that would disable SSH or the access-list...or open up your vtys
If you have CiscoWorks LMS, it might be easier to go into RME Admin settings for Configuration Management and change the Transport Protocol to SNMP over telnet/SSH and then do a similar config change using that tool.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...