Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Topology map

Good morning to all!

We have a CiscoWorks LMS 2.6 installation that manage a WAN network architecture (hub-and-spoke architecture). My question is sample: all links are 2 Mbps links and topology map represent these in correct way. In one case topology map draw a numb "2M" to connect the network devices: why?

In general: when topology map uses the numb to represent the links?

Thanks in advance for the answer

A.M

1 REPLY
Cisco Employee

Re: Topology map

I don't follow what you're describing.  Post a screenshot illustrating this problem.

151
Views
0
Helpful
1
Replies
CreatePlease to create content