cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
689
Views
0
Helpful
3
Replies

Topology Services

lambay2000
Level 2
Level 2

Hi,

When i click on the link attributes in Network Topology lan edge view it give me the error attached .

Thanks

1 Accepted Solution

Accepted Solutions

Yes, I mean HUM.  Since you do not have it installed, you will not be able to use that cross-launch option.

View solution in original post

3 Replies 3

Joe Clarke
Cisco Employee
Cisco Employee

Do you have the Health and Utilization Monitor add-on installed?  If not, then this cross-launch option will not work.

Hey Calrke,

Do u mean to say HUM module ?? if so then my LMS is not extended only basic,with RME,IPM,DFM,CM,CS,CWA,CV.LMS Portal.

Thanks

Yes, I mean HUM.  Since you do not have it installed, you will not be able to use that cross-launch option.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco