Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Topology view in LMS 3.2

Hi ,

The view of the network topology in topology services is not displayed properly,By mistake i have deleted 1 link from one of the switch to the another switch,am not able to get that link back i have ran the data collection many times but the link does'n't resume.

Thanks,

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Topology view in LMS 3.2

Then the link must really be gone.  Get the show cdp neighbor output on both ends, and confirm the link still shows up there.

4 REPLIES
Cisco Employee

Re: Topology view in LMS 3.2

Delete the devices on both ends of the link, then make sure those devices are not excluded under Campus Manager > Admin > Data Collection > Excluded Devices, then run a new Data Collection.

New Member

Re: Topology view in LMS 3.2

Hey clarke,

I tried by deleting devices on both the end but still the deleted link on one of the switch i can't get,

Thanks

Cisco Employee

Re: Topology view in LMS 3.2

Then the link must really be gone.  Get the show cdp neighbor output on both ends, and confirm the link still shows up there.

New Member

Re: Topology view in LMS 3.2

Hey clarke,

i have just disable the CDP and renable it ,the link in topology map came up.

Thanks

194
Views
0
Helpful
4
Replies