Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Traffic QOS on router with OID

Hi !

I monitor some routers with Nagios and I need to know the traffic of my QOS. I have found this two OID :

cbQosCMPostPolicyBitRate 1.3.6.1.4.1.9.9.166.1.15.1.1.11

And

cbQosCMPrePolicyBitRate 1.3.6.1.4.1.9.9.166.1.15.1.1.7

But, when I compare with my other plugin for Nagios which display the traffic in and out of my router I see that the traffic of my qos is just for the traffic_out.

I'm more interested in knowing what is the qos' traffic of my router for the traffic_in!

If there is another OID i'm interested because I haven't found it!

Thanks a lot,

7 REPLIES
New Member

Re: Traffic QOS on router with OID

Nobody for helping me? :)

New Member

Re: Traffic QOS on router with OID

Up?

Blue

Re: Traffic QOS on router with OID

Well, it depends on how you applied your QoS policies on the interface(s), e.g.:

Interface GigabitEthernet 10/1

...

service-policy [ output | input ] "policy-map-name"

New Member

Re: Traffic QOS on router with OID

When I use this oid : "policy-map-name" I have 2 responses :

"Wan"

"ethernet"

so my output is "wan" and input is "ethernet".

But how can I find my Qos traffic for this TWO interfaces?

Thanks a lot for your answer :)

New Member

Re: Traffic QOS on router with OID

The result of the command is :

SNMPv2-SMI::enterprises.9.9.166.1.6.1.1.1.1063 = STRING: "WAN"

SNMPv2-SMI::enterprises.9.9.166.1.6.1.1.1.1073 = STRING: "ETHERNET"

But when I search the cbQosCMPostPolicyRate I have :

SNMPv2-SMI::enterprises.9.9.166.1.15.1.1.11.1089.1093 = Gauge32: 262000

SNMPv2-SMI::enterprises.9.9.166.1.15.1.1.11.1089.1103 = Gauge32: 0

SNMPv2-SMI::enterprises.9.9.166.1.15.1.1.11.1089.1109 = Gauge32: 0

SNMPv2-SMI::enterprises.9.9.166.1.15.1.1.11.1089.1115 = Gauge32: 6000

SNMPv2-SMI::enterprises.9.9.166.1.15.1.1.11.1089.1119 = Gauge32: 271000

And this is only for the traffic out

How can I use my previous values (1063 and 1073) to get the traffic in of my qos?

New Member

Re: Traffic QOS on router with OID

up? :)

Bronze

Re: Traffic QOS on router with OID

As yjdabear stated,

This depends on the direction you have the QoS applied. If the policy is applied outbound: service-policy out, then you will be given the QoS rate for outbound traffic. If your other interface doesn't have a QoS Policy applied to it, you're not going to get anything.

810
Views
0
Helpful
7
Replies