Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Triggered capture on NAM-2 (Network Analysis Module)

Is anybody using the NAM-2 to perform traffic capture in their network? We have this installed in our core 7600 router. It's very convenient to perform a packet capture on any VLAN or interface on the router. But what we'd really like to do is trigger a capture session based on alarm generated by the NAM.

The alarm is firing, but it is not triggering the packet capture. We really need this to work as we are seeing what appears to be intermittent attacks, and need to able to capture it in progress.

If anybody has any suggestions or experience in this area it would be greatly appreciated!

Alarm is firing:

NAM-007.png

Capture never fires, even though Start Event is configured:

NAM-008.png

Sincerely,

~Daniel

Everyone's tags (2)
410
Views
0
Helpful
0
Replies