Hi there. New to the forum and all that. I have been perusing the content of the Entity MIB (RFC2737) obtained from a few 2611 routers we have in our lab here, and have found that the entParentRelPos values for the AIM slots conflict with similar values for C2600 daughtercard slots. Am I looking in the wrong location for slot numbers? Am I interpreting the numbers incorrectly? Any help would be appreciated since I am obviously somewhat new to all this.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...