I need to get accounting info from my access-points (AP1200, IOS 12.3)
ip dhcp pool wifi_pool_1
ip dhcp-server 192.168.1.9
aaa group server radius radius_1.97
server 192.168.1.97 auth-port 1812 acct-port 1813
aaa accounting network accout_rad start-stop group radius_1.97
dot11 ssid GUP
With this config everything works fine, but My radius server did not get IP-address of client in acc-start-packet.
This problem is usually solved by adding "aaa accounting delay-start" command. But in this example (when I use external DHCP server) it did not work. After adding "accounting delay-start" there are no accounting-packets sending at all.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...