Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Trunking Ports on catalyst 4506

Hi,

How can i configure on the 4506 a trunk mode for 2, 3 ports, cause i want to make a link agragation between two switches, on the other one which is a dell i already configure two statics ports for the agragation.

Thank you.

Joey

2 REPLIES
Community Member

Re: Trunking Ports on catalyst 4506

Hi, you can configure trunking on one or morw switchport, by default they carry traffic for all vlans. use etherchannel or port channel to group the port together for load balance and combined bandwidth. Have a look at the documents below.

http://www.cisco.com/en/US/docs/switches/lan/catalyst4500/12.1/12ew/configuration/guide/layer2.html

http://www.cisco.com/en/US/docs/switches/lan/catalyst4000/7.1/configuration/guide/channel.html

Community Member

Re: Trunking Ports on catalyst 4506

Thank you, i'll take a look.

Have a good day.

299
Views
0
Helpful
2
Replies
CreatePlease to create content