Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

tune the route

Hi,

we find that our router (73XX) utilization is following:

R1:

CPU utilization Gi ethernet usage

4.8% 2.5M

9% 3.8M

12% 5M

16% 8M

base on above figure, the CPU will grow to 100% when the bandwidth is nearly 41M - 52M

We enable the auto QoS, static route, 802.1Q (VLAN) and NAT. which one comsume the CPU time? any idea to tunne the serices (or move it to another devices). Please advice.

Best regards

1 REPLY

Re: tune the route

hi

obviously qos will be using the most and also NAT which mite end up in using the same level.

did u check for the process using high cpu cycles in ur router.

that will also help you out to find out the process and fine tune the same if possible.

regds

82
Views
0
Helpful
1
Replies